1. VELCRO INSTALLATION
Lay out the panels on the floor in the desired configuration, and use a pencil to mark the locations of panels. In case of installation near the bed, we suggest starting mounting from the mattress.
Clean the wall to remove any dust or residue to insure proper adhision
Peel velcro sticky back to the wall, attach, and firmly press onto the wall . Or nail the strip to the wall. This will minimize damage to the wall.
Attach the panels to the wall. You are all set! Then step back and admire your handiwork.
2. INSTALLATION WITH LIQUID NAILS
(HANDYMAN REQUIRED)
Determine the distance where the panel will be located.
Degrease the surface with an alcohol-containing substance.
Set the laser level.
Take panel with number 1. Apply glue to the 1st panel from the back side with small balls, 1 inch in diameter and stick it, pressing it well against the wall. We are not recommend to hit the panel hard, as the adhesive layer may become thinner, which will lead to poor adhesion.
Start the installation from the bottom up, according to the numbering of the instructions on the panels.
If you have inlays, then take the molding according to the scheme, apply a strip of glue no more than 0.3 inch thick and stick it. The thickness of the adhesive must not exceed 0,3 inch.
Remove excess glue with foam rubber.
Proceed the installation
